Pharos-science-applications iGPS-BT II Manual de usuario

iGPS-BT II User Manual

6. Enter the passkey: 12345678 7. Put a check mark in the box next to “serial port” and tap Finish 8. Next select the “COM Ports” tab at the

10. Select Com 7, and make sure that there is a check in the “Secure Connection” box and tap Finish. 11. Close down the Bluetooth Settings screen a

….. ….. 14. The Smiley Face should go from Red to Yellow when searching for satellites and finally to Green when a GPS lock for navigation has been e

Battery Precautions (w: WARNING!) 1.w Reverse charging is not acceptable. 2. Charge before use. The cells/batteries are delivered in an uncharged

IV. iGPS-BT II GPS Receiver Specifications Performance Chipset SiRF StarIII GSC3f Antenna Integrated patch antenna Frequency L1, 1575.42 MHz Sen

V. Precautions • Position fixing may not be available when this receiver is used near high-voltage wire, electronics equipment that generates elec

VIII. Troubleshooting For any troubleshooting assistance, please check the Frequently Asked Questions section at www.pharosgps.com. IX. Warranty

FCC Notices This device complies with Part 15(b and c) of the FCC Rules. Operation is subject to the following conditions: • This device may not c

I. iGPS-500 Receiver and Bluetooth Dock iGPS-BT II Dock iGPS-500 Receiver DC Jack for charging On/Off Switch Battery charging indicator (Orang

II. iGPS-BT II Setup (see walkthrough guides at the end of this section) 1. The iGPS-BT II will need to be charged for two to three hours before i

Walkthrough Guides 1. iGPS-BT II Setup for Pocket PCs with built-in Bluetooth Technology running the Windows Mobile Pocket PC OS (the following scree

5. Provided that your iGPS-BT II is turned on and fully charged, it will be discovered. Tap on the “Pharos iGPS-BT” icon to select it 6. Enter the

9.Tap and hold on the “Pharos iGPS-BT: GPS RFcom” icon, select “Connect” from the Menu that appears 10. Once the GPS has a connection, the icon wil

13. Now that the COM Port is setup, you can Enable the GPS by tapping on the RED Smiley face 14. Select “YES” to Enable the GPS Bluetooth setup

2. iGPS-BT II Setup for Pocket PCs with built-in Bluetooth Technology running the Windows Mobile 5.0 OS (the following screen shots show the device a